CTI Products RadioPro Betriebsanweisung PDF herunterladen (Seite 9)

RadioPro Dispatch Installation and Configuration Guide

System Considerations

System Planner Template

Use the System Planner Template at the end of this document to record device names, passwords, and IP addresses.

IP Gateway and Control Station Radio Configuration

Before installing the RadioPro Dispatch client, the IP Gateway(s) must be configured using the ICU.exe utility (IP

Configuration Utility) and installed on an IP network. In addition, the Control Station(s) must be configured using the

manufacturer’s configuration software. See IP Gateway Installation Guide S2-61781 for more details.

GPS Mapping Support

Note: GPS Mapping is not available in all configurations. Please check with CTI Products for more details.

Mapping of subscriber radios requires the following:

 IP Gateways must have GPS enabled using ICU.exe

 Control Station radios CANNOT have GPS or ARS enabled

 Subscriber radios MUST have GPS and ARS enabled

Version Match

RadioPro Dispatch clients, Talk clients, and IP Gateways must have compatible versions in order to communicate with

each other. Compatibility can be ensured when the first two digits of the version match. (The third digit indicates a minor

revision, and does not need to match.)

In addition, the license file for a RadioPro Dispatch client must be at the same major revision level. In other words, a

RadioPro Dispatch software license key for version 7 is required to run RadioPro Dispatch version 7. (A version 6 license

key will not be able to run RadioPro Dispatch version 7.)

Control Station Radio Version

The control station radio connected to the IP Gateway must at least have the minimum firmware version listed below.

Control Station Radio

Minimum Version

Motorola MOTOTRBO in Conventional, IPSC, Cap+, or LCP 1.08.0

Motorola MOTOTRBO in Connect Plus mode 2.2.0

Motorola MOTOTRBO Connect Plus Option Board 1.3.0

Kenwood NEXEDGE NX-800 1.23.00

PC Settings for Power and Display

Power Settings

The Power Settings should be adjusted so that the PC does NOT hibernate or sleep. Use the Power Options item in

the Control Panel to make these adjustments.

Display Properties

The RadioPro Dispatch client has been designed to be used with display monitors with the following display properties:

 Font Size – Normal

 DPI - Normal (96DPI)

Altering the above settings may cause some information for the RadioPro Dispatch client to be displayed improperly.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Keine Kommentare

CTI Products RadioPro Betriebsanweisung Seite 9